![]() Roll Stability Control (RSC) switch (2010), RSC (2010), 4x4 module, 4x4 switch, Heated seat switches, Reverse park aid (2010) Restraints its control module, Passenger occupancy, PAD lamp (2006-2007) Radio, Trailer tow battery charge (relay in PDB) Ignition switch power, Passive anti-theft system (PATS), ClusterĦ-speed Transmission control module/Powertrain control module (Ignition RUN/START), Fuel pump relayįront wiper RUN/ACC relay in power distribution box (PDB) Moon roof, Power down back window, Door lock switch illumination (2008-2010), Auto dimming rear view mirror (2010), Rearview mirror with microphone (2008-2009) To remove a fuse use the fuse puller tool provided on the fuse panel box. ![]() The fuse panel is located below the instrument panel on the driver’s side. If a fuse blows again contact a qualified service center. ![]() Use always an intact fuse of the same color. Never replace a broken fuse with anything other than a new fuse.Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Always replace a fuse with one that has the specified amperage rating.Always disconnect the battery before servicing high current fuses.Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |